[RegCNET] new diag + enable output : re SST preproc fail

Solmon Fabien fsolmon at ictp.it
Fri Apr 5 14:09:46 CEST 2013


Hello !

For general information, in the last release candiate regcm 4.4 (beta) , 
there is a new possibility of saving and outputing every term of the the 
temperature tendency (adv,dif,conv,turb, bdy etc ) as part of the ATM 
file. This option is enabled if idiag=1 in the outparam nameliste.  In 
this case there are 7 additional 3d variable in addition  to the normal  
output containing 10 variables.

In addition there is also the possibility to specify outputs we want in 
the files using the logical table : enable_atm_var , still in the 
outparam namelist.

Now in response to James email :  I saw that in your regcm.in you have 
used the option to enable 17 ATM outputs by setting the enable_atm_var 
to 17*.true., however you did not enable the idiag option ... there 
might be a problem here, we need to double check.

best regards
Fabien




On 03/28/2013 07:58 PM, James Ciarlo` wrote:
> Hi,
>
> I am trying to run a basic simulation with the attached regcm.in 
> <http://regcm.in> file, but I am getting an error that I cannot 
> recognise that seems to be related to the SST.
>
> The error seems to happen during the preproc of ssts.
>
> Regards,
> James
>
>
> _______________________________________________
> RegCNET mailing list
> RegCNET at lists.ictp.it
> https://lists.ictp.it/mailman/listinfo.cgi/regcnet


-- 
---------------------------------------------------
Fabien Solmon
Research Scientist
+39 040 2240206 (office) | Earth System Physics
+39 040 2240449 (fax)    | ICTP (UNESCO-IAEA)
esp.ictp.it              | Strada Costiera 11
                          | 34014 Trieste, Italy

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.ictp.it/pipermail/regcnet/attachments/20130405/e7b4d686/attachment.htm>


More information about the RegCNET mailing list