Hello !
For general information, in the last release candiate regcm 4.4
(beta) , there is a new possibility of saving and outputing every
term of the the temperature tendency (adv,dif,conv,turb, bdy etc )
as part of the ATM file. This option is enabled if idiag=1 in the
outparam nameliste. In this case there are 7 additional 3d
variable in addition to the normal output containing 10
variables.
In addition there is also the possibility to specify outputs we
want in the files using the logical table : enable_atm_var , still
in the outparam namelist.
Now in response to James email : I saw that in your regcm.in you
have used the option to enable 17 ATM outputs by setting the
enable_atm_var to 17*.true., however you did not enable the idiag
option ... there might be a problem here, we need to double check.
best regards
Fabien
On 03/28/2013 07:58 PM, James Ciarlo` wrote:
Hi,
I am trying to run a basic simulation with the attached
regcm.in
file, but I am getting an error that I cannot recognise
that seems to be related to the SST.
The error seems to happen during the preproc of ssts.
Regards,
James
_______________________________________________
RegCNET mailing list
RegCNET@lists.ictp.it
https://lists.ictp.it/mailman/listinfo.cgi/regcnet
--
---------------------------------------------------
Fabien Solmon
Research Scientist
+39 040 2240206 (office) | Earth System Physics
+39 040 2240449 (fax) | ICTP (UNESCO-IAEA)
esp.ictp.it | Strada Costiera 11
| 34014 Trieste, Italy