I am a postgraduate from Beijing Normal University. Recently, I start to learn use RegCM-4.7.1 version to simulate dust. When I used ERA5 to drive RegCM, I found that there is no "ERA5" in namelist &globdatparam dattype (see picture below) . I tried to set dattyp='ECMWF', but there was error when use the ICBC (Initial Condition, Boundary Conditions) program (see picture below), I am sure that the path of input data is correct (see picture below) . I cannot find the useful information to solve this problem in the Internet . I am sincerely looking forward your help. Thank you!