Dear Joshua,
I can’t say for certain what the problem is, but there are two common things to check when getting this issue with a new domain: (1) reduce dt, and (2) modify the domain to avoid cutting across high topography at the boundaries.
My guess is that (1) isn’t going to help, since you have a dt of 120s in your file and a grid spacing of 60km: that corresponds to an advective CFL parameter of about 0.1 for ~60 m/s upper-level winds, which should be stable. It’s worth a try though: reduce dt by ½ and see if it helps.
My hunch is that (2) is the problem. I’ve attached an annotated version of the topography that is generated when I run terrain on your namelist file. I’ve circled regions where the boundary cuts across relatively high topography. Such regions can be problematic for stability. I suggest trying to change the geometry of your domain to avoid cutting across high topography to the extent possible. It’s not always possible to totally avoid cutting across topography; in that case, try to cut across as low an elevation as possible.
With Kind Regards,
-Travis-
--
Travis A. O'Brien
Pronouns: he/him
Assistant Professor
Earth and Atmospheric Sciences
Indiana University, Bloomington
Visiting Faculty
Climate and Ecosystem Sciences Division
Lawrence Berkeley Lab
Topical Editor
Geoscientific Model Development
I am trying to run a simulation over west Africa but I keep getting this error message despite efforts to resolve it:
"READY BC from 1992060118 to 1992060200
ATM variables written at 1992-06-01 18:00:00 UTC
SRF variables written at 1992-06-01 18:00:00 UTC
SHF variables written at 1992-06-01 18:00:00 UTC
RAD variables written at 1992-06-01 18:00:00 UTC
MAXVAL ATEN T : 2.0630375226624444
II : 40 , JJ : 76 , KK : 13
MAXVAL ATEN U : 1.0182738287789692
II : 40 , JJ : 77 , KK : 10
MAXVAL ATEN V : 1.0219311819551942
II : 40 , JJ : 76 , KK : 2
WHUUUUBBBASAAAGASDDWD!!!!!!!!!!!!!!!!
No more atmosphere here....
CFL violation detected, so model STOP
#####################################
# DECREASE DT !!!! #
#####################################
-------------- FATAL CALLED ---------------
Fatal in file: mod_tendency.F90 at line: 695
CFL VIOLATION
-------------------------------------------
mod_tendency.F90 : 695: 1
Abort called by computing node 0 at 2022-03-07 06:42:27.650 +0000
Execution terminated because of runtime error
--------------------------------------------------------------------------
MPI_ABORT was invoked on rank 0 in communicator MPI COMMUNICATOR 3 DUP FROM 0
with errorcode 1.
NOTE: invoking MPI_ABORT causes Open MPI to kill all MPI processes.
You may or may not see output from other processes, depending on
exactly when Open MPI kills them."
Please find attached the test file.