Dear all,


I am running RegCM-4.5.0, however I got this error:

===================================================
18      0.9900      0.9950      0.0100       0.5000       0.5000       0.5000
 19      1.0000
  Constant hor. diff. coef. =  0.200000E+04 m^2 s-1
  Maximumt hor. diff. coef. =  0.208333E+05 m^2 s-1
 DOMAIN FILE :   9.969209968386869E+036
 NAMELIST    :    5.00000000000000
 Mismatch: PTOP in DOMAIN file /= PTOP in namelist
 Abort called by computing node            0 at 2016-07-23 18:12:11.437 +0200
--------------------------------------------------------------------------
MPI_ABORT was invoked on rank 0 in communicator MPI COMMUNICATOR 3 DUP FROM 0
with errorcode 1.
===================================================




here is the namelist.in:

!
! DOMAIN geolocation Stanza
!
 &geoparam
 iproj = 'LAMCON', ! Domain cartographic projection. Supported values are:
                   ! 'LAMCON', Lambert conformal.
                   ! 'POLSTR', Polar stereographic.
                   ! 'NORMER', Normal  Mercator.
                   ! 'ROTMER', Rotated Mercator.
 ds = 2.0,        ! Grid point horizontal resolution in km
 ptop = 5.0,       ! Pressure of model top in cbar
 clat = -21.20,     ! Central latitude  of model domain in degrees
                   ! North hemisphere is positive
 clon = 55.50,     ! Central longitude of model domain in degrees
                   ! West is negative.
 plat = -21.20,     ! Pole latitude (only for rotated Mercator Proj)
 plon = 55.50,     ! Pole longitude (only for rotated Mercator Proj)
 truelatl = 30.0,  ! Lambert true latitude (low latitude side)
 truelath = 60,    ! Lambert true latitude (high latitude side)
 i_band = 0,       ! Use this to enable a tropical band. In this case the ds,
                   ! iproj, clat, clon parameters are not considered.
 /

===================================================


And then, I check the domain file:


/scratch/cnt0025/eep7640/ctang/Modeling/LaReunion_1/input >> ncks -v ptop LaReunion_DOMAIN000.nc
ptop: type NC_FLOAT, 0 dimensions, 3 attributes, chunked? no, compressed? no, packed? no
ptop size (RAM) = 1*sizeof(NC_FLOAT) = 1*4 = 4 bytes
ptop attribute 0: long_name, size = 21 NC_CHAR, value = Pressure at model top
ptop attribute 1: standard_name, size = 12 NC_CHAR, value = air_pressure
ptop attribute 2: units, size = 3 NC_CHAR, value = hPa

ptop = 50 hPa

/scratch/cnt0025/eep7640/ctang/Modeling/LaReunion_1/input >>
===================================================

Any ideas ?



Thanks a lot in advance.







Best regards,
Chao TANG

-------------------------------------------------------------------------------------------------
Laboratoire d'Energétique, d'Electronique et Procédés 
Unité de Recherche EA 4079 
Université de La Réunion, LE2P
15 avenue René Cassin CS 92003
97744 ST DENIS CEDEX 9
-------------------------------------------------------------------------------------------------