Hello Graziano,

I succeeded in running CH4 module by putting the correct settings in namelist.

I attached the namelist including CH4 parameters.

Regards

Samy

----- Forwarded Message -----
From: Graziano Giuliani <ggiulian@ictp.it>
To: ‪Samy Rateb‬ ‪ <ratebsamy@yahoo.com>
Sent: Monday, 17 August 2015, 14:05:09
Subject: Re: failure to run CN + LCH4 due to error in CH4 namelist

On 08/17/15 14:00, ‪Samy Rateb‬ ‪ wrote:
> Hello Graziano,
[...]
>  ch4conrd                        error in reading in ch4par_in namelist
[..]

You have to add the namelist to the input file.

&ch4par_in
/

I have never used this part of the code, the namelist should be the same
as it is for the CLM 4.5, so you should again refer to its original
documentation.

In the code, a number of parameters can be set. Look in the
mod_clm_ch4varcon.F90 file.




G.


--
Graziano Giuliani - Earth System Physics Section
The Abdus Salam International Centre for Theoretical Physics
Strada Costiera 11 - I - 34151 Trieste Italy