Dear James,

May you be looking diffirent atmosfer level temperature. Your diriving.png might be surface or near surface level and preproc.png might be 300 mb level temperature. I advice you to check they are same level or not.

with my best wishes

On Thu, Feb 27, 2014 at 5:31 PM, James Ciarlo` <james.ciarlo@physics.org> wrote:

Dear RegCNET,

I am running various simulations with HadGEM2-ES as driving data. However, there is a serious problem, the temperature is being produced at about -60 degC.

My simulations are based on the Mediterranean, and these temperatures cannot be possible. I have checked the HadGEM2 data (driving.png) and the values are fine, but after preprocessing (preproc.png) I get these values. This has happened on a long (16 year) RF run and a short RCP45 (1.5 year, namelist attached) run.

Is there something wrong in my namelist somewhere? Or is there a problem with the processing of this data in the model?

Regards,

James

_______________________________________________
RegCNET mailing list
RegCNET@lists.ictp.it
https://lists.ictp.it/mailman/listinfo.cgi/regcnet

--

Yrd. Doc. Dr. Burak ŞEN
Niğde Üniversitesi Tarım Bilimleri ve Teknolojileri Fak.
Biyosistem Mühendisliği Böl.Bşk.
Merkez Yerleşke, Bor Yolu Üzeri, Niğde, 51240
Tel : 0388 225 4455/4454
GSM : 5066285503
Fax:  0388 225 4440
mail:buraksen33@gmail.com
      :bsen@nigde.edu.tr

Assit.Prof.Dr. Burak SEN
Nigde University
Faculty of Agricultural Sciences and Technologies
Head of Biosystems Engineering Department
Land and Water Resource
51240, Niğde, Turkey

Tel : +90 0388 225 4455/4454
GSM :+90 5066285503
Fax: +90 0388 225 4440
mail:buraksen33@gmail.com
      :bsen@nigde.edu.tr

Mobile:5066285503
mail:buraksen33@gmail.com
       bsen@nigde.edu.tr