Can someone send me a working regcm.in file for RegCM4.4 so that I can experiment a bit and possibly figure out this problem


On 8 April 2013 14:48, James Ciarlo` <james.ciarlo@physics.org> wrote:
Hi Dr Solmon,

I added the idiag = 1 in the outparam, but the errors are still the same

Regards


On 5 April 2013 14:09, Solmon Fabien <fsolmon@ictp.it> wrote:
Hello !

For general information, in the last release candiate regcm 4.4 (beta) , there is a new possibility of saving and outputing every term of the the temperature tendency (adv,dif,conv,turb, bdy etc ) as part of the ATM file. This option is enabled if idiag=1 in the outparam nameliste.  In this case there are 7 additional 3d variable in addition  to the normal  output containing 10 variables.

In addition there is also the possibility to specify outputs we want in the files using the logical table : enable_atm_var , still in the outparam namelist. 

Now in response to James email :  I saw that in your regcm.in you have used the option to enable 17 ATM outputs by setting the enable_atm_var to 17*.true., however you did not enable the idiag option ... there might be a problem here, we need to double check.

best regards
Fabien 




On 03/28/2013 07:58 PM, James Ciarlo` wrote:
Hi,

I am trying to run a basic simulation with the attached regcm.in file, but I am getting an error that I cannot recognise that seems to be related to the SST.

The error seems to happen during the preproc of ssts.

Regards,
James


_______________________________________________
RegCNET mailing list
RegCNET@lists.ictp.it
https://lists.ictp.it/mailman/listinfo.cgi/regcnet


-- 
---------------------------------------------------
Fabien Solmon
Research Scientist
+39 040 2240206 (office) | Earth System Physics  
+39 040 2240449 (fax)    | ICTP (UNESCO-IAEA)  
esp.ictp.it              | Strada Costiera 11  
                         | 34014 Trieste, Italy

_______________________________________________
RegCNET mailing list
RegCNET@lists.ictp.it
https://lists.ictp.it/mailman/listinfo.cgi/regcnet