Dear Hamza,
I faced similar problem when I was trying to read the ECHAM SST
data in RegCM-4.1 preprocessor. When I check the SST code, I found two errors
in "mod_sst_eh5om.f90" file under "RegCM-4.1/PreProc/ICBC"
folder. If you make the following corrections, you will successfully read the
SST data.
Line 265, replace "ieh5ostart = 1989010100" with
"ieh5ostart = 1941010100" and
Line 376, replace "ieh5orec = idatediff(idate,
ieh5ostart)" with "ieh5orec = idatediff(idate, ieh5ostart)/idtbc +
1"
I hope this will solve your problem as it worked for me.
Best regards,
Solomon
From:
regcnet-bounces@lists.ictp.it [mailto:regcnet-bounces@lists.ictp.it] On
Behalf Of hamza altinsoy
Sent: Wednesday, June 08, 2011 12:14 AM
To: regcnet
Subject: [RegCNET] ECHAM5 sst/icbc problem
Dear all,
When I tried to use ECHAM data set , I faced a problem during sst.
When I run terrain,clm2rcm, aeresol , Everything is okey but when I tried to
run sst it gives this error
"record number outside range, unit 11, file
/home/hamza/Desktop/data/SST/SST_20C_3_1962010100_1993123118"
When I tried the same regcm.in with ERA40/OI_WK ,
it works.
I downloaded my data set from http://users.ictp.it/~pubregcm/RegCM4/globedat.htm#part6
I think, It may stem from the globwindow part and I used the above coordinate
conditions
&globwindow
lat0 = -89.0625
lat1 = 89.0625
lon0 = 0.0
lon1 = 358.125
/
I also try
&globwindow
lat0 = 0.0
lat1 = 0.0
lon0 = 0.0
lon1 = 0.0
/
but it didn't work
How can I solve this problem?
Thank you very much