Dear RegCM users, After succefully running the RegCM3 I can not proceed with the post processing system due to the following error [rajesh@localhost RunEURO]$ ./postproc.x ifort -tpp7 -O3 -cm -w -w90 -w95 -Vaxlib -convert big_endian -c -o postproc.o postproc.f fortcom: Error: postproc.f, line 8113: This name does not have a type, and must have an explicit type. [N3D] real f3(im,jm,km,n3d),f2(im,jm,n2d) --------------------------^ fortcom: Error: postproc.f, line 8113: A specification expression is invalid. [N3D] real f3(im,jm,km,n3d),f2(im,jm,n2d) --------------------------^ fortcom: Error: postproc.f, line 8113: This name does not have a type, and must have an explicit type. [N2D] real f3(im,jm,km,n3d),f2(im,jm,n2d) ----------------------------------------^ fortcom: Error: postproc.f, line 8113: A specification expression is invalid. [N2D] real f3(im,jm,km,n3d),f2(im,jm,n2d) ----------------------------------------^ compilation aborted for postproc.f (code 1) make: *** [postproc.o] Error 1 mv: cannot stat `../PostProc/postproc': No such file or directory ./postproc: Command not found. This happens in the PC with Redhat Enterprise Linux WS3. Surprisingly this run properly in my Laptop with Fedora 8. Can anybody point out what could be wrong with this? Appreciate any thought over this. Thanks Mr. Rajesh J. Junior Research Fellow, Department of Atmospheric Sciences, School of Marine Sciences, Cochin University of Science and Technology, Lakeside Campus, Finearts Avenue, Cochin 682016 Phone: 9846812663 e-mail: rajeshj@cusat.ac.in |